Disconnect the electrical connectors (Item 1) [Figure 50-111-18] from the control lever switch handle. Remove the electrical connectors from the control lever switch handle. (See…
Author: Jack
Remove the handle sleeve (Item 1) and bushings (Item 2) from the handle [Figure 50-111-16]. Check all parts for wear and replace as needed. Check…
Remove the handle sensor (Item 1) [Figure 50-111-12]. (See Handle Sensor Removal And Installation on Page 50-111-1.) Remove the switch handle (Item 1) [Figure 50-111-13].…
Loosen the nuts (Item 1) [Figure 50-111-2]. Installation: Tighten the u-bolts so the lever can not be moved either right or left when seated in…
The control handles/levers are used to control the forward and reverse travel and the lift and tilt functions.The lift and tilt functions can be controlled…
To replace the rubber boot (Item 1) [Figure 50-110-2] on the control panel, remove the control lever (See Lever Removal And Installation on Page 50-110-1.)…
Disconnect the electrical connectors (Item 1) [Figure 50-110-1]. Remove the nuts from the two U-bolts (Item 2) [Figure 50-110-1] used to mount the control lever.…
Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.) Raise the operator cab. (See Raising on Page…
With the option of SJC you receive a control panel that has two electronic handles that control the steering, lift and tilt functions. There is…
NOTE: When the linkage travel adjustment procedure is being done as part of the loader neutral adjustment procedure, check the torsion bushings at the pump…