Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.) Raise the operator cab.(See Raising on Page 10-30-2.)…
Author: Jack
The control pedals send an electronic pulse to the actuators on the control valve. The electronic pulse tells the actuators to move the lift or…
After installing the pedal, adjust the pedal angle so that there is clearance under the rear of the pedal. The valve spool must travel full…
Remove the crossbar pivot bolt and washer (Item 1) [Figure 50-90-3]. Remove the bolt, washer and nut (Item 1) [Figure 50-90-4] to disconnect the lift…
Raise the lift arms and install an approved lift arm support device.(See Installing on Page 10-20-1.) Raise the operator cab.(See Raising on Page 10-30-2.) Remove…
The control pedals and linkages are connected to the control valve. The control pedals will mechanically move the lift and tilt spools on the control…
Disconnect the fuel fill hose (Item 1) [Figure 50-80-7] from the fuel tank. Remove the fuel inlet screen (Item 1) [Figure 50-80-8]. Clean and dry…
Raise the loader operator cab. (See Raising on Page 10-30-2.) Disconnect the harness (Item 1) and loosen the fuel level sender (Item 2) [Figure 50-80-5]…
Remove the cover (Item 1) [Figure 50-80-1] which is installed over the fuel drain near the rear of the chaincase. Installation: Tighten the cover mounting…
Disconnect the spring (Item 1) [Figure 50-70-7] from the rear door. Remove the bolt and nut (Item 2) [Figure 50-70-7] from the latch. Remove the…