Loosen the striker assembly mount bolts (Item 1) [Figure 50-70-6]. Align the striker assembly in the center of the mounting holes. NOTE: Tighten the striker…
Author: Jack
Remove the lock nut (Item 1) [Figure 50-70-5]. Remove the rollers (Item 2) and the spacer (Item 3) from the bolt (Item 4) [Figure 50-70-5].…
Remove the two striker mount bolts (Item 1) [Figure 50-70-4]. Remove the striker assembly from the loader.
Disconnect the light harness connector (Item 1) [Figure 50-70-1] from the engine harness. Remove both rear lights (Item 2) [Figure 50-70-1] from the door. (See…
Open the rear door. Lift up on the rear grill (Item 1) [Figure 50-60-1] and [Figure 50-60-2]. Lift the grill away from the loader. Installation:…
Roll the Bob-Tach fully forward. Stop the engine. Remove the Bob-Tach frame from the lift arms. (See Removal And Installation on Page 50-40-1.) Install jackstands…
Remove the Power Bob-Tach. (See Removal And Installation on Page 50-41-1.) Remove the rubber seal (Item 1) [Figure 50-41-13]. Installation: Use a new seal when…
Remove and replace the Bob-Tach stop (Item 1) [Figure 50-41-12] (both sides) if worn or damaged. NOTE: The Bob-Tach stop (Item 1) [Figure 50-41-12] must…
Use the following procedure to remove and install the Bob-Tach lever (Item 1) [Figure 50-41-6], spring and wedge. Use a punch and hammer, remove the…
Tilt the Bob-Tach forward, so it is parallel to the floor. Put blocks (approximately 3 inches) under each side of the Bob-Tach [Figure 50-41-1]. Lower…