Clean the block (Item 1) [Figure 20-130-5] to remove dirt before disassembly. Block ports are labeled for correct assembly. Remove the plug (Item 2) [Figure…

Lift and block the loader. (See Procedure on Page 10-10-1.) Raise the lift arms and install an approved lift arm support device. (See Installing on…

The Power Bob-Tach block is an option that allows the operator to hydraulically control the Bob-Tach levers for mounting and dismounting the attachments. The power…

Clean the diverter valve to remove dirt before disassembly. Valve ports are labeled for correct assembly. Remove the two mount bolts (Item 1) from the…

Lift and block the loader. (See Procedure on Page 10-10-1.) Raise the lift arm and install an approved lift arm support device. (See Installing on…

Use a test meter to measure coil resistance [Figure 20-120-1]. Coil wires do not have polarity. Correct resistance is 8.6 – 9.5 ohm @ 68…

The rear auxiliary diverter valve is an optional valve that diverts oil from the front auxiliary circuit to two sets of rear auxiliary couplers or…

Remove the solenoid nut (Item 1) [Figure 20-110-10]. Installation: Tighten the solenoid nut to maximum 6 ft.- lb. (8 N•m) torque. Remove the solenoid (Item…

Start the engine. Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.) Stop the engine. Raise the…

Use a test meter to measure coil resistance [Figure 20-110-4]. Coil wires do not have polarity. Correct resistance for the coil is 9.7 ohm ±…