Raise the operator cab. (See Raising on Page 10-30-2.) Disconnect the wire harness connector (Item 1) [Figure 20-110-1] from the bucket position shutoff solenoid. Remove…
Author: Jack
The Bucket Position Valve is an option that allows the loader to meter the lift and tilt circuits. The metering of the lift and tilt…
Remove the rear grill from the loader. (See Removal And Installation on Page 50-60-1.) Install tool MEL 1558 (Item 1) to outside of rubber sleeve…
The oil cooler is used to cool the loaders hydraulic and hydrostatic oil. Oil passages are coiled into a heat exchanger. Air is forced, with…
Remove the fill cap (Item 1) from the hydraulic reservoir (Item 2) [Figure 20-90-4]. Remove the hydraulic fluid screen (Item 1) [Figure 20-90-5] from the…
Lift and block the loader. (See Procedure on Page 10-10-1.) Start the engine. Raise the lift arms and install an approved lift arm support device.…
The hydraulic fluid reservoir is a storage container for the loaders hydraulic/hydrostatic fluid. The reservoir contains a vented fill cap with a fluid screen to…
Remove filter outlet hose (Item 1) and inlet hose (Item 2) [Figure 20-80-5]. Disconnect the electrical connector (Item 3) [Figure 20-80-5] from the charge pressure…
Stop the engine and open the rear door. Drain the hydraulic fluid. (See Removing And Replacing Hydraulic Fluid on Page 10-120-2.) Remove the mounting bolt…
The hydraulic/hydrostatic filters help to remove contaminants from the hydraulic fluid when the hydraulic/ hydrostatic systems are operating. The hydraulic/hydrostatic filter system consists of one…