The alternator is removed from the loader for clarity purposes [Figure 60-30-3].
Disconnect the negative (-) cable from the battery.
Install the wires in their original location on the back of the alternator.
Connect a jumper wire (Item 1) [Figure 60-30-3] to the alternator output terminal and the regulator terminal.
Connect the battery negative (-) cable.
Start the engine and run at 2600 RPM.
If the reading is within 45-55 amps. at 2600 RPM replace the rectifier (diode) assembly or replace the alternator.
If the reading is low, do the Alternator Regulator Test.
