Stop the engine. Pull up on the lift arm by-pass control and move the lift pedal to release the hydraulic pressure.
Disconnect the hoses (Item 1) [Figure 20-20-3] from the lift cylinder.
Install plugs in the hoses and tighten.
Remove the retainer bolt (Item 1) [Figure 20-20-4] and nut from the lift arm pin (both sides).
Installation: Tighten the bolt and nut to 18-20 ft.-lbs. (24-27 Nm) torque.
NOTE: Remove the air cleaner (See AIR CLEANER SERVICE on Page 10-80-1.) to remove the left rear pivot pin. The pin must be driven out from the engine compartment.
Remove the lift arm pivot pin (Item 1) [Figure 20-20-5] (both sides).
Remove the retainer bolt (Item 1) [Figure 20-20-6] and nut from the lift cylinder rod end pivot pin (both sides).
Installation: Tighten the bolt and nut to 18-20 ft.-lbs. (24-27 Nm) torque.
Remove the lift cylinder rod end pivot pin (Item 2) [Figure 20-20-6].
Remove the lift cylinder (Item 3) [Figure 20-20-6] from the loader.
