Remove the attachment. Roll the Bob-Tach fully back.
Stop the engine. Raise the seat bar.
Disconnect the hose (Item 1) [Figure 20-21-1] which goes to the base end of the tilt cylinder.
Install a cap on the fitting and tighten.
Engage the parking brake. Lower the seat bar.
Start the engine and push the Press to Operate button.
Push the bottom (heel) of the tilt pedal.
If there is leakage from the open port, remove the tilt cylinder for repair.
Remove the attachment. Roll the Bob-Tach forward and lower the lift arms.
Place the Bob-Tach flat on a pallet to allow the tilt cylinder base end pin enough clearance to be removed [Figure
20-21-2].
Stop the engine. Move the tilt pedal to release the hydraulic pressure. Raise the seat bar.
