Mark the pump sections for correct assembly [Figure 20-60-9].
Remove the pump housing bolts (Item 1) [Figure 20-60-9].
Installation: Tighten bolts to 35 ft.-lbs. (47,5 Nm) torque.
Remove the end housing (Item 1) [Figure 20-60-10].
Remove the O-ring (Item 2) [Figure 20-60-10].
Remove the bearing housing (Item 1) [Figure 20-60-11] from the pump body.
Remove the seal (Item 1) and back-up seal (Item 2) [Figure 20-60-12] from the bearing housing.
Remove the drive gear (Item 1) and idler gear (Item 2) [Figure 20-60-13].
Remove the other end bearing housing (Item 1) [Figure 20-60-14].
Remove the O-ring (Item 2) [Figure 20-60-14].
Remove the bearing housing (Item 1) [Figure 20-60-15] from the pump body.
Remove the seal (Item 1) and back-up seal (Item 2) [Figure 20-60-16] from the bearing housing.
