Raise the seat bar (Item 1) [Figure 50-10-1].
Disconnect the seat bar sensor (Item 1) [Figure 50-10-2] from the cab harness.
Lower the seat bar.
Loosen the nut (both sides) at the front corners of the operator cab [Figure 50-10-3].
Remove the nuts and plates (both sides) [Figure 50-10-3].
Installation: Tighten the nuts to 40-50 ft.-lbs. (54-68 Nm) torque.
Lift on the grab handle and bottom of the operator cab slowly until the cab is all the way up and the latching
mechanism engages [Figure 50-10-4].
Remove the seat bar mounting nuts (Item 1) [Figure 50-10-5] (both sides).
Installation: Tighten the nuts to 28 ft.-lbs. (38 Nm) torque.
Lower the operator cab. (See Lowering The Operator Cab on Page 10-30-2.)
Remove the seat bar (Item 1) [Figure 50-10-6] from the operator cab.
Reverse the above procedure to install the seat bar into the operator cab.
