Remove the seat bar (Item 1) [Figure 60-100-5] from the loader. (See Removal And Installation on Page 50-10-1.)
Remove the mounting bolt (Item 1) from the seat bar mount (Item 2) [Figure 60-100-6].
Installation: Tighten the mounting bolt to 50-70 in.-lbs. (5,6-7,9 Nm) torque.
Remove the sensor mounting bolt (Item 3) [Figure 60-100-6] and nut.
Remove the keyed plastic bushing (Item 1), magnetic bushing assembly (Item 2) and sensor bracket (Item 3) [Figure 60-100-7].
Installation: Be sure the tabs on the pivot bushing are positioned in the slotted hole (Item 1) [Figure 60-100-7] of the seat bar.
Inspect all parts for damage and wear and replace if necessary.
Reverse the removal procedure to install the seat bar sensor.
