BOBCAT S130 โ€“ CONTROL SYSTEM (ACS) โ€“ Handle Lock Solenoid Removal And Installation

Disconnect the harness connector (Item 1) [Figure 60-130-24] from the handle sensor connector.

Disconnect the harness connector (Item 2) [Figure 60-130-24] from the handle lock solenoid connector.

Remove the two screws (Item 1) [Figure 60-130-25] holding the handle lock solenoid to the handle.

Installation: Tighten the screws to 32 โ€“ 38 in.-lb. (3,6 โ€“ 4,3 Nโ€ขm) torque.

Remove handle lock solenoid assembly from handle.