Remove the drive belt shield. (See Shield Removal And Installation on Page 30-60-1.)
Remove the drive belt. (See Belt Removal And Installation on Page 30-60-3.)
Remove the drive belt tension pulley. (See Tensioner Pulley Removal And Installation on Page 30-60-4.)
Remove the six mounting bolts (Item 1) from the engine flywheel (Item 2) [Figure 70-110-1].
Installation: Apply engine oil to the threads and seats before tightening. Tighten to 72 – 80 ft.-lb. (98 – 108 Nโขm) torque.
Remove the flywheel from the engine.
Installation: Be sure to align the hole in the flywheel with the pin located on the crankshaft.
Reverse the removal procedure to install the flywheel.
