Stop the engine and open the rear door.
Remove the negative (-) and positive (+) cables from the battery.
Disconnect the ground wire (Item 1) [Figure 60-40-3] from the starter.
Disconnect the engine harness power wire and positive (+) battery cable from the starter solenoid terminal (Item 2) [Figure 60-40-3].
Installation: Tighten the nut to 10.8 – 12.3 ft.-lb. (14,7 – 16,7 Nโขm) torque.
Disconnect the tan wire (Item 3) [Figure 60-40-3] from the R terminal on the starter solenoid.
Disconnect the brown wire (Item 4) [Figure 60-40-3] from the S terminal on the starter solenoid.
Remove the mounting bolts (Item 5) [Figure 60-40-3] from the starter.
Remove the starter from the engine.
Installation: Tighten the three mounting bolts to 25 – 28 ft.-lb. (34 – 38 Nโขm) torque.
Reverse the removal procedure to install the starter.
