Touch one probe to a bare stator lead and the other probe to the bare metal surface of the stator [Figure 60- 31-19]. There should…

Use an ohmmeter to test the stator. Touch the probes to two of the bare stator wires [Figure 60-31-18]. Move one of the probes to…

Disassemble the alternator [Figure 60-31-17]. Remove the regulator cover. Remove the four bolts holding halves together. Pry the halves apart (use a press if needed).…

Touch one probe to the “L” terminal (Item 1) and the other probe to the ground (Item 2) [Figure 60-31-15]. Reverse the probes to check…

Remove the two screws (Item 1), nut/washer (Item 2) and the plastic cover (Item 3) [Figure 60-31-11] from the alternator. NOTE: In the diode tests…

Place jack stands under the rear corners of the loader. Raise the lift arms and install an approved lift arm support device. (See Installing Lift…

Turn engine OFF and remove the L & S Terminal connector (Item 1) [Figure 60-31-6] off the alternator. Check the continuity between the “S” terminal…

Turn engine OFF and remove the L & S terminal connector (Item 1) [Figure 60-31-6] off the alternator. Turn the remote start tool key to…

Open tailgate. Connect the remote start tool to the loader. (See REMOTE START on Page 10-60-1.) Turn the engine on with the remote start tool…

If the charging system malfunctions check the following: Check the condition and tension of the alternator belt. (See Adjusting The Alternator Belt on Page 60-31-1.)…