Remove the old seal (both sides) from the end of the tilt cylinder [Figure 20-21-8]. Apply a light coat of grease on the new seals…

Disconnect both hydraulic hoses (Items 1 & 2) [Figure 20-21-3]. Remove the retainer nut (Item 1) [Figure 20-21-4] from the cylinder rod end pivot pin.…

Remove the attachment. Roll the Bob-Tach fully back. Stop the engine. Raise the seat bar. Disconnect the hose (Item 1) [Figure 20-21-1] which goes to…

Use the following tools to assembly the cylinder: MEL1396 – Seal Installation Tool MEL1033 – Rod Seal Installation Tool Piston Ring Compressor Spanner Wrench Wash…

Use the following tools to disassemble the cylinder: MEL1074 – O-ring Seal Hook Spanner Wrench Hold the hydraulic cylinder over a drain pan and move…

Stop the engine. Pull up on the lift arm by-pass control and move the lift pedal to release the hydraulic pressure. Disconnect the hoses (Item…

Lower the lift arms. Stop the engine. Pull up on the lift arm by-pass control. Raise the seat bar. Check only one cylinder at a…