Install the cylinder head gasket. Put the piston (Item 1) [Figure 70-100-11] being checked at T.D.C. Put three pieces of 0.060 inch (1,5 mm) diameter…

Clean the surface of the cylinder head. Put a straight edge (Item 1) [Figure 70-100-9] on the cylinder head. NOTE: Do not put the straight…

Use a valve spring compressor to compress the valve spring [Figure 70-100-6]. Remove the valve cap (Item 1) [Figure 70-100-6] & [Figure 70-100-7] and valve…

Remove the nuts from the valve cover, remove the valve cover and gasket [Figure 70-100-1]. Remove the fuel injector nozzles. (See Fuel Injector Removal And…

When reinstalling the RPM sensor, turn the rpm sensor (Item 1) [Figure 70-91-1] in until it makes contact with the engine flywheel. Turn the jam…

Remove the RPM sensor. (See RPM SENSOR on Page 70-91-1.) Loosen the drive belt tensioner bolt (Item 1) [Figure 70-90-5] from the housing and remove…

NOTE: Photo’s may be different but the procedure is the same for all models. Remove the flywheel. (See Flywheel Removal And Installation on Page 70-90-1.)…

Remove the three belt shield clips (Item 1) [Figure 70-90-1] and remove the shield from the drive belt housing. Loosen and remove the drive belt…

Use the following procedure to install new engine mounts: Remove the existing mount from the engine. Refer to engine removal and installation for engine mount…

Put jackstands under the rear corners of the loader. Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm…