Remove the three drive belt shield mounting clips (Item 1) [Figure 30-60-1]. Remove the belt shield (Item 1) [Figure 30-60-2]  

The drive belt makes the mechanical connection from the engine flywheel to the hydrostatic pump pulley. The belt is a cord-reinforced rubber design. Constant tension…

The hydraulic controller neutral adjustment, aligns the pump swash plate and the control spool so that a zero angle control setting provides a zero degree…

The pump mechanical neutral adjustment sets the position of the servo piston and pump swash plate relative to the hydraulic controller. This procedure should be…

Remove the hydrostatic pump/engine assembly from the loader. (See Engine Removal And Installation on Page 70-10-8.) Remove the hydraulic controllers (Item 1) [Figure 30-51-21]. (See…

The charge relief valve (Item 1) [Figure 30-51-18] is located on the back of the hydrostatic pump. Remove the charge relief valve. Assembly: Tighten charge…

There are four system check relief valves (Item 1) [Figure 30-51-15] in the back of the hydrostatic pump. Remove the relief valve cap (Item 1)…

Before putting a hydrostatic pump back into operation, the hydrostatic pump should be filled with hydrostatic fluid. This should be performed when installing a new…

Remove the engine/hydrostatic pump assembly from the loader. (See Engine Removal And Installation on Page 70-10-8.) Remove the control handle linkage from the hydrostatic pump.…