Raise the loader lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.) Raise the loader operator cab. (See Raising…

The brake is used to hold the machine in place. The brake is operated by a switch (Item 1) [Figure 40-10-1] located on the front…

Remove the case drain filter(s) from the machine. (See Removing And Replacing Case Drain Filters on Page 10-120-4.) Remove the filter housing nut (Item 1)…

The case drain filter is an external filter assembly in the case drain circuit that filters the case drain hydraulic oil. The case drain filter…

Install the spring (Item 1) on the pulley (Item 2) [Figure 30-60-15] as shown. Install the shaft from the bracket assembly (Item 1) into the…

Remove the grease cover (Item 1) [Figure 30-60-11]. Remove the bolt (Item 1), the flat washer (Item 2), the retainer washer (Item 3), the spring…

Stop the engine. Open rear door. Remove the negative (-) cable from the battery. the battery may be removed for additional working clearance. (See Removal…

Stop the engine. Open the rear door. Raise the operator cab. (See Raising on Page 10-30-2.) Remove the negative (-) cable from the battery. The…

To adjust the drive belt between the flywheel and the hydrostatic pump pulley, use the following procedure: Stop the engine. Open the rear door. Disconnect…