Raise the loader lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.) Lift and block the loader. (See Procedure…

The tool listed is necessary for the following procedure: MEL1420 – Carrier Seal Tool Remove the hydrostatic motor. (See Removal And Installation on Page 30-20-1.)…

The hydrostatic motor carrier is the mating connection from the hydrostatic drive motor to the transmission case. The hydrostatic motor carrier contains a shaft that…

Drain the oil from the motor. Seal all open ports and clean the motor with solvent. Put a mark across the sections of the motor…

Raise the operator cab. (See Raising on Page 10-30-2.) Remove the front and rear wheel/tire assemblies. (See TIRE MAINTENANCE on Page 10-160-1.) Raise the lift…

The hydrostatic motors are driven by high pressure from the hydrostatic pumps. In this system there is a case drain filter for each motor to…

The hydrostatic system consists of a tandem hydrostatic pump and two hydrostatic motors. The hydrostatic system allows forward and reverse motion of the loader. The…

The following troubleshooting chart is provided for assistance in locating and correcting problems which are most common. Many of the recommended procedures must be done…