Remove filter outlet hose (Item 1) and inlet hose (Item 2) [Figure 20-80-5]. Disconnect the electrical connector (Item 3) [Figure 20-80-5] from the charge pressure…

Stop the engine and open the rear door. Drain the hydraulic fluid. (See Removing And Replacing Hydraulic Fluid on Page 10-120-2.) Remove the mounting bolt…

The hydraulic/hydrostatic filters help to remove contaminants from the hydraulic fluid when the hydraulic/ hydrostatic systems are operating. The hydraulic/hydrostatic filter system consists of one…

The tools listed will be needed to do the following procedure: MEL1563 or 6689779 – Remote Start Tool MEL10103 – Hydraulic Tester MEL10106 – Hydraulic…

The tools listed will be needed to do the following procedure: MEL1563 or 6689779 – Remote Start Tool MEL10103 – Hydraulic Tester MEL10106 – Hydraulic…

The tools listed will be needed to do the following procedure: MEL10003 – In-Line Hydraulic Tester MEL10006 – Flowmeter Fitting Kit NOTE: When testing the…

The hydraulic gear pump is attached to the end of the hydrostatic pumps and is located on the right side of the loader between the…

Mark the pump sections for correct assembly [Figure 20-60-22]. Remove the eight pump housing bolts (Item 1) [Figure 20-60-22]. Installation: Tighten the bolts (Item 2)…