Ensure the hydrostatic reservoir is filled to the correct level before starting the engine. (See Checking And Adding Fluid on Page 10-120-1.) NOTE: Because the…
Category: BOBCAT S130
Lift and block the rear of the loader. (See Installing on Page 10-20-1.) Raise the lift arms and install an approved lift arm support device.…
The tools listed will be needed to do the following procedure: MEL1563 or 6689779 – Remote Start Tool MEL10103 – Hydraulic Tester MEL10106 – Hydraulic…
The tools listed will be needed to do the following procedure: MEL1563 or 6689779 – Remote Start Tool MEL10103 – Hydraulic Tester MEL10106 – Hydraulic…
The tools listed will be needed to do the following procedure: MEL10003 – In-Line Hydraulic Tester MEL10006 – Flowmeter Fitting Kit NOTE: When testing the…
The hydraulic gear pump is attached to the end of the hydrostatic pumps and is located on the right side of the loader between the…
Remove the bypass valve (Item 1) [Figure 20-50-4] from the valve block. Inspect the bypass valve for damage and replace if necessary. Installation: Tighten the…
Install jack stands under the rear corners of the loader. Start the engine. Raise the lift arms and install an approved lift arm support device.…
Raise the lift arms 6 feet (2 m) off the ground. Stop the engine. Turn the Lift Arm Bypass Control Knob (Item 1) [Figure 20-50-1]…
The lift arm bypass control valve is located on the right side of the machine close to the engine speed control. The lift arm bypass…