The lift arm bypass control valve is located in front of the operator’s seat. The lift arm bypass control valve is manually operated by turning…

Assembly: The plastic bushing (Item 1) [Figure 20-40-86] is inserted from the bottom of the flange as shown. Remove the two nuts (Item 1) [Figure…

Remove the hair pin (Item 1) [Figure 20-40-84] and the link from the auxiliary spool on the control valve. Remove the bolt (Item 1) [Figure…

To install new spool seals when the centering spring (tilt spool) or other detent assembly (lift spool) are not removed from the spool, use the…

Wrap a rag (Item 1) [Figure 20-40-72] around the detent ball retainer and the centering spring. Slowly remove the retainer from the balls. The detent…

Remove the screws (Item 1) and rubber boot (Item 2) [Figure 20-40-69] from the linkage end of the control valve. Remove the spool seal retainer…

Put the linkage end of the spool in a vise and install the MEL 1285 Compression Spring Tool (Item 1) [Figure 20-40-65] Remove the bolt…

Remove the lift and tilt lock block (Item 1) [Figure 20-40-61] from the control valve. (See Lift And Tilt Lock Block Removal And Installation on…

Put the linkage end of the spool assembly [Figure 20-40-48] in a vise. Install MEL1285 Spring Compressor Tool (Item 1) [Figure 20-40-48] on the spring…

The tool listed will be needed to do the following procedure: MEL 1278 – Detent Tool MEL 1285 – Detent Spring Tool Remove the lift…