The following test should be done after reassembling the starter: Clamp the starter in a vise. Using a 12 volt battery and ammeter, connect the…
Inspect the brush cover for discoloration, indication the starter has been overheated. Inspect the pinion teeth for wear and damage. Armature Short-Circuit Test: Use a…
Remove the cable (Item 1) [Figure 60-41-6] from the magnetic switch. Remove the bolts (Item 2) [Figure 60-41-6]. Installation: Tighten the bolts to 63-129 ft.lbs.…
Stop the engine and open the rear door. Remove the negative (-) and positive (+) cables from the battery. Disconnect the ground wire (Item 1)…
The key switch must be in the OFF position. The battery must be at full charge. The cable connections on the battery must be clean…
Clean all parts and apply high temperature grease to the armature bearing, return spring, steel ball, over running clutch, and idler gear rollers. Install the…
The following test should be done after reassembling the starter: Clamp the starter in a vise. Using a 12 volt battery and ammeter, connect the…
Inspect the brush cover for discoloration, indication the starter has been overheated. Inspect the pinion teeth for wear and damage. Armature Short-Circuit Test: Use a…
Remove the cable (Item 1) [Figure 60-40-5] from the magnetic switch. Remove the bolts (Item 1) [Figure 60-40-6]. Remove the frame (Item 1) [Figure 60-40-7]…