Stop the engine and open the rear door. Remove the negative (-) and positive (+) cables from the battery. Remove the starter mounting bolt (Item…

The key switch must be in the OFF position. The battery must be at full charge. The cable connections on the battery must be clean…

Reverse the order of disassembly. Do not assemble the rear case half. Place the rotor in soft jaws when tightening the shaft nut (Item 1)…

Touch one probe to one of the slip rings and the other probe to the rotor shaft [Figure 60-31-21]. There should be no continuity. Replace…

Touch the probes to the slip rings [Figure 60-31-20]. The ohmmeter should read between 3.0-4.0 ohms. If there is no continuity replace the rotor.

Touch one probe to a bare stator lead and the other probe to the bare metal surface of the stator [Figure 60- 31-19]. There should…

Use an ohmmeter to test the stator. Touch the probes to two of the bare stator wires [Figure 60-31-18]. Move one of the probes to…

Disassemble the alternator [Figure 60-31-17]. Remove the regulator cover. Remove the four bolts holding halves together. Pry the halves apart (use a press if needed).…

Touch one probe to the “L” terminal (Item 1) and the other probe to the ground (Item 2) [Figure 60-31-15]. Reverse the probes to check…