Disassemble the right and left steering shafts from the cross shaft assembly [Figure 50-110-3]. Assembly: Install new nylon bushings (Item 1) [Figure 50-110-3] as needed…

NOTE: The steering shaft can be removed without removing the control panel from the loader. Photo [Figure 50-               …

Remove the mounting nut (Item 1) [Figure 50-110-1] from the end of the shock connected to the steering linkage. Remove the mounting nut (Item 2)…

Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Raise the operator cab.…

Remove the bolt (Item 1) holding the linkage (Item 2) [Figure 50-91-7] to the side of the foot pedal. Remove the spacer (Item 1), linkage…

Remove the pin (Item 1) [Figure 50-91-5] holding the linkage to the sensor. Tip the foot pedal up and remove the two nuts (Item 1)…

Pull the pin (Item 1) [Figure 50-91-1] holding the foot pedal linkage to the sensor. Disconnect the two connectors (Item 2) [Figure 50-91-1] from the…

Remove the hairpin clip and cross-pin (Item 1) [Figure 50-90-9] to disconnect the tilt foot pedal linkage from the control valve. Remove the bolt (Item…

Remove the bolt and nut (Item 1) [Figure 50-90-7] to disconnect the lift foot pedal linkage from the crossbar linkage. Remove the bolt (Item 1)…

Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Raise the operator cab.…