The following tool listed will be needed to do the following procedure: MEL1563 or 6689779 – Remote Start Tool Kit Connect the remote start tool…

Remove the bolt (Item 1) from the pintle solid cams (Item 2) [Figure 50-100-24] and inspect the pintle solid cams for damage or excessive wear.…

Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.) Lift and block the loader. (See Procedure on…

Disassemble the right and left steering bellcranks (Item 1) from the cross shaft assembly [Figure 50-100-12]. Assembly: Install new nylon bushings (Item 2) [Figure 50-100-12]…

NOTE: The steering shaft can be removed without removing the control panel from the loader. Photo [Figure 50-100-11] shows the control panel removed for clarity…

Remove the mounting nut (Item 1) [Figure 50-100-10] from the end of the shock connected to the steering linkage. Remove the mounting nut (Item 2)…

Raise the lift arms and install an approved lift arm support device. (See Installing on Page 10-20-1.) Raise the operator cab. (See Raising on Page…

The steering system [Figure 50-100-1] consists of independent steering levers the operator uses to provide steering input to the loader. The steering levers are attached…

Remove the bolt (Item 1) holding the linkage (Item 2) [Figure 50-91-7] to the side of the foot pedal. Remove the spacer (Item 1), linkage…

Remove the pin (Item 1) [Figure 50-91-5] holding the linkage to the sensor. Tip the foot pedal up and remove the two nuts (Item 1)…