The bucket side cutting edges (Item 1) [Figure 40-170-4] are reversible. Remove the two bolts and nuts (Item 1) [Figure 40-170-5]. Installation: Tighten the nuts…

Position the bucket so the bucket teeth are at a 30° angle up from the ground for accessibility to the teeth. Lower the boom until…

To determine the correct number and thickness of the shims needed, the inside of the outer arm and the outside of the inner arm will…

Build the service tool to assist in aligning the rod end of the cylinder between the left and right rod end pin boss. Use the…

Remove the seals (Item 1) [Figure 40-161-8] from both sides of the arm. Remove the bushings (Item 2) [Figure 40-161-8] from both sides of the…

Remove the seals (Item 1) [Figure 40-161-6] from both sides of the arm. Remove the bushings (Item 2) [Figure 40-161-6] from both sides of the…

Remove the bucket or attachment. (See the Operation and Maintenance Manual for the correct procedure.) Fully retract the arm and install the pin (Item 1).…

Remove the seals (Item 1) [Figure 40-160-5] from both sides of the arm. Remove the bushings (Item 1) [Figure 40-160-6] from both sides of the…

Remove the seals (Item 1) [Figure 40-160-3] from both sides of the arm. Remove the bushings (Item 2) [Figure 40-160-3] from both sides of the…

Remove the arm cylinder. (See Removal And Installation on Page 20-22-3.) Support the arm with a chain hoist (Item 1) [Figure 40-160-1]. Remove the hydraulic…