Close and latch the front and rear sliding windows. Use a pick to pull the felt (Item 1) [Figure 40-30-15] from the top window channel.…

With a second person supporting the window, partially raise the window. Remove the clips (Item 1) [Figure 40-30-12] from the gas strut on both sides…

The door can be removed from the cab by slowly swinging the door back and forth while lifting up on the door [Figure 40-30-11]. Installation:…

Build the service lifting bracket used to remove and install the cab. Use the dimensions shown [Figure 40-30-1] to build the service lifting bracket. Remove…

Build the service lifting bracket used to remove and install the ROPS canopy. Use the dimensions shown [Figure 40-20-1] to build the service lifting bracket.…

Rotate the swing bearing so the outside soft zone (Item 1) [Figure 40-10-6] is to the right hand side as shown. Use a tap in…

Lower the blade all the way. Put all the control levers in neutral. Remove the boom. (See Removal And Installation on Page 40-150-1.) Remove the…

If reusing the existing swing bearing, use the alignment marks to put the swing bearing in the correct location. If installing a new swing bearing…

Remove the upperstructure. (See Removal on Page 40-10-1.) Mark the swing bearing to track frame. Remove the 24 bolts (Item 1) [Figure 30-40-1] and nuts…

The following pages show photos and illustrations of track damage and the probable cause of the damage. It is intended to be used for identifying…