Disconnect the harness connector (Item 1) [Figure 60-130-24] from the handle sensor connector. Disconnect the harness connector (Item 2) [Figure 60-130-24] from the handle lock…

NOTE: Actuator shown removed for clarity. Not necessary for procedure. Check the actuator wiring harness connector (Item 1) [Figure 60-130-22] and replace if broken. Installation:…

When installing the new switch handle, tape the wire terminals together. The switch handle comes with a 6 inch piece of heat shrink tubing placed…

NOTE: Switch handle can be removed and installed while in loader. Disconnect the harness connector (Item 1) [Figure 60-130-4] from the handle sensor connector. Disconnect…

The wire connector (Item 1) [Figure 60-130-1] can be removed from the handle sensor wires, using the following procedure. Remove the wedge (Item 1) [Figure…

The Advanced Control System (ACS) has a built-in diagnostic function which uses an icon on the right instrument panel to indicate the condition of the…

The (ACS) Actuator Control System system is an option that allows the operator to quickly switch between foot and hand control modes. The ACS control…

Fasten the seat belt, disengage the parking brake button, press the PRESS TO OPERATE LOADER Button (Item 1) [Figure 60-120-13] and raise the Seat Bar…

Raise the loader operator cab. (See Raising on Page 10-30-2.) NOTE: The loader control panel and linkage crossbar have been removed for clarity purpose only.…

The following troubleshooting chart is provided for assistance in locating and correcting BICS system problems. It is recommended that these procedures be done by authorized…