Raise the seat bar (Item 1) [Figure 50-10-1]. Disconnect the seat bar sensor (Item 1) [Figure 50-10-2] from the cab harness. Lower the seat bar.…
Author: Jack
Disconnect the front steering linkage bars from the rear linkage bars. (See Linkage Removal And Installation on Page 50-110-3.) Move the linkage bars to allow…
Disconnect and remove the engine speed control from the control panel. (See Removal And Installation on Page 70-20-1.) Remove the control panel from the loader.…
Raise the loader lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Raise the loader…
To drain the oil from the chaincase, remove the cover (Item 1) [Figure 40-30-2] which is installed over the drain plug at the rear of…
The chaincase contains the final drive sprockets and chains and uses the same type of oil as the hydraulic/ hydrostatic system. (See Hydraulic System on…
Raise the loader lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Lift and block…
The tools listed are needed for the following procedure: MEL1242 – Power Ram MEL1202B – Axle Bearing Service Set Raise the lift arms and install…
The tools listed are needed for the following procedure: Axle Hub Puller Tool MEL1399 – Seal Driver Tool MEL1242 – Power Ram (may be used…
The parking brake switch in the front panel (Item 1) [Figure 40-10-13] replaced the pedal parking brake. (See Removal And Installation on Page 60-50-9.)