Raise the loader lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Raise the loader…
Author: Jack
Loosen and remove the mounting bolt (Item 1) and nut from the spring mounting bracket (Item 2) [Figure 40-10-7]. Remove the brake pedal spring (Item…
Raise the loader operator cab. (See Raising The Operator Cab on Page 10-30-1.) Remove the two mounting bolts (Item 1) [Figure 40-10-5] from the brake…
Following tool is necessary to perform this procedure: MEL1558 Open the rear door of the loader. Raise the rear grill [Figure 30-60-1]. Disconnect the inlet…
Install the spring (Item 1) on the pulley (Item 2) [Figure 30-50-15] as shown. Install the shaft from the bracket assembly (Item 1) into the…
Remove the grease cover (Item 1) [Figure 30-50-11]. Remove the bolt (Item 1), the flat washer (Item 2), the retainer washer (Item 3), the spring…
Stop the engine. Open rear door. Remove the negative (-) cable from the battery. the battery may be removed for additional working clearance. (See Removal…
Stop the engine. Open the rear door. Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.) Remove the negative (-) cable from…
To adjust the drive belt between the flywheel and the hydrostatic pump pulley, use the following procedure: Stop the engine. Open the rear door. Disconnect…