Remove the three drive belt shield mounting clips (Item 1) [Figure 30-50-1].
Author: Jack
Install the lower bearing (Item 1) [Figure 30-40-36] on the swashplate. Install the swashplate and bearing into the pump housing [Figure 30-40-37]. Install the tapered…
Remove the four bolts (Item 1) [Figure 30-40-12] from the pump housing end cap. Remove the pump housing end cap (Item 1) [Figure 30-40-13]. Remove…
Remove the four mounting bolts (Item 1) [Figure 30-40-9]. Separate the two hydrostatic pumps [Figure 30-40-10]. Remove the pump coupler (Item 1) [Figure 30-40-11]. Remove…
Remove the pump mounting bolts (Item 1) [Figure 30-40-7] (both sides). Installation: Tighten the mounting bolts to 27-37 ft.-lbs. (37-50 Nm) torque. Remove the hydraulic…
Remove the engine/hydrostatic pump assembly from the loader. (See Hydraulic Pump Removal And Installation on Page 30-40-8.) Loosen the drive belt tensioner (Item 1) [Figure…
There are four replenishing/high pressure relief valves (Item 1) [Figure 30-40-1] in the hydrostatic pump assembly. Two are located at the top of the pumps…
If the charge pressure is not correct loosen the charge relief valve plug (Item 1) [Figure 30-30-2]. Assemble: Always use a new O-ring. Tighten the…