Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.) Open the rear door. Disconnect the wires (Item 1) [Figure 30-30-1]…
Author: Jack
Open the rear door. Disconnect the wires (Item 1) [Figure 30-30-1] from the charge pressure sender. Remove the charge pressure sender (Item 2) [Figure 30-30-1]…
Put the motor carrier housing in the press as shown [Figure 30-20-65]. Use 4-5/16 inch driver tool and press the new inner bearing race into…
It is necessary to locate or fabricate a press tool for this procedure. Refer to photo [Figure 30-20-59] for the correct dimensions of the tool…
Raise the loader lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Lift and block…
The tool listed is necessary for the following procedure: MEL1420 – Carrier Seal Tool Remove the hydrostatic motor. (See Removal And Installation on Page 30-20-1.)…
Clean all parts with solvent and dry with compressed air. Put grease on O-rings. Lubricate parts with oil. Install the poppet (Item 1) and spring…
Drain the oil from the motor. Seal all open ports and clean the motor with solvent. Put a mark across the sections of the motor…