Inspect cartridges, check valves, solenoid valves and sealing washers for contamination or damage. Wash all parts in clean solvent. Use air pressure for drying them.…
Author: Jack
Use a test meter to measure coil resistance [Figure 20-101-23]. Coil wires do not have polarity. Correct resistance is 6-9 ohms. Replace the test meter…
Clean the diverter block to remove dirt before disassembly. Block ports are labeled for correct assembly. Remove the logic cartridge valves (Item 1) [Figure 20-101-9]…
Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.) Raise the lift arms and install an approved lift arm support…
Put oil on O-rings and back-up washers. Tighten the Logic cartridge valves (Item 1) [Figure 20-100-9] to 65 ft. lbs. (88 Nm) torque. Tighten the…
Use a test meter to measure coil resistance [Figure 20-100-12]. Coil wires do not have polarity. Correct resistance is 6-9 ohms. Replace the test meter…
Inspect cartridges, check valves, solenoid valves and sealing washers for contamination or damage. Wash all parts in clean solvent. Use air pressure for drying them.…
Clean the diverter block to remove dirt before disassembly. Block ports are labeled for correct assembly. Remove the logic cartridge valves from block ports LC1…
Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.) Raise the lift arms and install an approved lift arm support…
Remove the solenoid nut (Item 1) [Figure 20-90-9]. Installation: Tighten the nut to 60 in.-lbs. (6,78 Nm) torque. Remove the solenoid (Item 1) and the…