Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.) Raise the lift arms and install an approved lift arm support…
Author: Jack
Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.) Raise the lift arms and install an approved lift arm support…
The Advanced Control System (ACS) includes the Advanced Hand Controls (AHC) and/or the Selectable Hand/Foot Control.
Clean all components with clean solvent and dry with compressed air. Check the spools for wear or scratches. Check that the spools are not loose…
Remove the plug (Item 1) [Figure 20-40-119] or optional port relief valve from the control valve. NOTE: Optional port relief (Item 1) [Figure 20-40-119] is…
Remove the nut (Item 1) [Figure 20-40-116] from both solenoids. Installation: Tighten the nut to 8-12 ft.-lbs. (11-16 Nm) torque. Remove the coil (Item 1)…
Remove the screws (Item 1) [Figure 20-40-114] from the end cap (both sides). Installation: Tighten the bolt to 90-100 in.-lbs. (10,2-11,3 Nm) torque. Remove the…
Remove the lift and tilt lock block (Item 1) [Figure 20-40-106] from the control valve. (See Lift And Tilt Lock Block Removal And Installation on…
The tool listed will be needed to do the following procedure: MEL1278 – Detent Tool MEL1285 – Detent Spring Tool Remove the lift and tilt…
Remove the lock solenoids (Item 1) [Figure 20-40-68] & [Figure 20-40-69] from the lock block. Remove the rubber Boot (Item 2) [Figure 20-40-68] & [Figure…