Author: Jack
The tools listed will be needed to do the following procedure: MEL1563 or 6689779 – Remote Start Tool MEL10103 – Hydraulic Tester MEL10106 – Hydraulic…
The tools listed will be needed to do the following procedure: MEL1563 or 6689779 – Remote Start Tool MEL10103 – Hydraulic Tester MEL10106 – Hydraulic…
The tools listed will be needed to do the following procedure: MEL10003 – In-Line Hydraulic Tester MEL10006 – Flowmeter Fitting Kit NOTE: When testing the…
The hydraulic gear pump is attached to the end of the hydrostatic pumps and is located on the right side of the loader between the…
Mark the pump sections for correct assembly [Figure 20-60-22]. Remove the eight pump housing bolts (Item 1) [Figure 20-60-22]. Installation: Tighten the bolts (Item 2)…
Ensure the hydrostatic reservoir is filled to the correct level before starting the engine. (See Checking And Adding Fluid on Page 10-120-1.) NOTE: Because the…
Lift and block the rear of the loader. (See Installing on Page 10-20-1.) Raise the lift arms and install an approved lift arm support device.…
The tools listed will be needed to do the following procedure: MEL1563 or 6689779 – Remote Start Tool MEL10103 – Hydraulic Tester MEL10106 – Hydraulic…