The tools listed will be needed to do the following procedure: MEL1563 or 6689779 – Remote Start Tool MEL10103 – Hydraulic Tester MEL10106 – Hydraulic…
Author: Jack
The tools listed will be needed to do the following procedure: MEL10003 – In-Line Hydraulic Tester MEL10006 – Flowmeter Fitting Kit NOTE: When testing the…
The hydraulic gear pump is attached to the end of the hydrostatic pumps and is located on the right side of the loader between the…
Remove the bypass valve (Item 1) [Figure 20-50-4] from the valve block. Inspect the bypass valve for damage and replace if necessary. Installation: Tighten the…
Install jack stands under the rear corners of the loader. Start the engine. Raise the lift arms and install an approved lift arm support device.…
Raise the lift arms 6 feet (2 m) off the ground. Stop the engine. Turn the Lift Arm Bypass Control Knob (Item 1) [Figure 20-50-1]…
The lift arm bypass control valve is located on the right side of the machine close to the engine speed control. The lift arm bypass…
Remove the tubeline (Item 1) [Figure 20-41-102]. Remove the check valve fitting (Item 1) [Figure 20-41-103] from the hydraulic control valve. Installation: Lubricate the O-ring…
Remove the main relief valve (Item 1) [Figure 20-41-100]. Remove the O-rings from the main relief valve (Item 1) [Figure 20-41-101]. Installation: Always use new…
Remove the fitting (Item 1) [Figure 20-41-98] from the valve. Check the lift arm bypass orifice (Item 1) [Figure 20-41-99]. NOTE: This orifice is not…