Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.)
Remove the Bobcat controller mount from the frame.
(See Removal And Installation on Page 60-70-4.)
Disconnect the wire harness connector (Item 1) [Figure 20-90-1] from the bucket position shutoff solenoid.
Remove the solenoid nut (Item 2) [Figure 20-90-1].
Installation: Tighten the solenoid nut to 60 in.-lbs. (6,78 Nm) torque.
Remove the solenoid stem (Item 1) [Figure 20-90-2] from the bucket position valve.
Installation: Put oil on O-rings and back-up washers and tighten the solenoid stem to 30-35 ft.-lbs. (40,8-47,6 Nm)
torque.
Inspect the solenoid stem and replace the O-rings (Item 1) and the back-up washer (Item 2) [Figure 20-90-3].
