To remove the handle sensor, slide the rubber handle cover (Item 1) [Figure 50-113-3] up the handle.
Disconnect the loader control harness (Item 1) [Figure 50-113-4] from the handle sensor harness.
Disconnect the loader control harness (Item 2) [Figure 50-113-4] from the handle connector.
Using a small screwdriver remove the handle sensor electrical connector (Item 1) from the clip by pushing the
connector down out of the connector clip (Item 2) [Figure 50-113-5].
Using a small screwdriver, remove the electrical connector (Item 1) from the clip by pushing the connector down out of the connector clip (Item 2) [Figure 50-113-6].
Using an allen wrench, remove one of the two mounting screws (Item 1) [Figure 50-113-7] from the handle sensor.
Installation: Tighten the handle sensor mounting screws to 85 in.-lbs. (9,6 Nm) torque.
Remove the spacers (Item 1) [Figure 50-113-8] & [Figure 50-113-9] while removing the mounting pin (Item
2) [Figure 50-113-8].
