Lower the work group to the ground.
With the engine off, turn the key to the ON position and move both hydraulic control levers to relieve hydraulic pressure.
Support the boom with a chain hoist (Item 1) [Figure 20-22-7].
Support the arm cylinder (Item 1) [Figure 20-22-8].
Remove the nuts (Item 1) and bolt (Item 2) [Figure 20-22-9].
Remove the rod end pin (Item 3) [Figure 20-22-9].
Remove the hose (Item 1) and hose clamp (Item 2) [Figure 20-22-10].
Remove the hose (Item 1) [Figure 20-22-11].
Install a sling (Item 1) [Figure 20-22-12] on the cylinder.
Remove the snap ring (Item 1), washer and base end pin (Item 2) [Figure 20-22-13].
Remove the cylinder.
