Remove the lift spool lock solenoid (Item 1) and the tilt spool lock solenoid (Item 2) [Figure 20-40-43] from the end cap/spool lock block.
Disconnect the tube line (Item 1) [Figure 20-40-44] from the end cap/spool lock block.
Remove the four end cap/spool lock block mount screws (Item 1) [Figure 20-40-45].
Installation: Tighten the screws to 90 – 100 in.-lb. (10 -11,3 Nโขm) torque.
Remove the rubber boots and retainer plate from the lift and tilt spools.
Remove the end cap/spool lock block (Item 1) [Figure 20-40-46] from the control valve.
