Put jackstands under the front and rear of the loader.
(See Procedure on Page 10-10-1.)
Raise the lift arms and install the lift arm support device.
(See Installing on Page 10-20-1.)
Raise the operator cab. (See Raising on Page 10-30-1.)
Disconnect the hose (Item 1) [Figure 20-70-1] from the filter block.
Disconnect the electrical connector from the charge pressure sender (Item 2) and the temperature sender (Item 3) [Figure 20-70-1].
Remove the drain hose (Item 1) [Figure 20-70-2] from the filter block.
Remove the inlet tubeline (Item 2) [Figure 20-70-2] from the filter block.
Remove the two mounting bolts (Item 1) [Figure 20-70-3] from the outside of the fender.
Remove the hydraulic filter block.
