When installing the new switch handle, tape the wire terminals together. The switch handle comes with a 6 inch piece of heat shrink tube side…

NOTE: Switch handle can be removed and installed while in loader. Disconnect the harness connector (Item 1) [Figure 60-122-10] from the handle sensor connector. Disconnect…

The wire connector (Item 1) [Figure 60-122-7] can be removed from the handle sensor wires, use the following procedure. Remove the wedge (Item 1) [Figure…

Remove control panel. (See Removal and Installation on Page 50-100-1.) Remove the two mounting bolts (Item 1) [Figure 60-122-5] from the controller mounting bracket. Lift…

The Advanced Control System (ACS) has a built-in diagnostic function which uses an icon on the right instrument panel to indicate the condition of the…

Control Handle (Item1) [Figure 60-122-1]. Handle Sensor (Item 2) [Figure 60-122-1]. NOTE: The calibration procedure must be followed when replacing handle sensor, foot pedal sensor,…

Remove the actuator from the hydraulic control valve. (See Actuator Removal And Installation on Page 20-41-8.) Check the mounting block (Item 1) [Figure 60-121-26] and…

To remove the switch handle, the connector (Item 1) [Figure 60-121-18] must be removed from the wires. Remove the wedge (Item 1) [Figure 60-121-19] from…

The wire connector (Item 1) [Figure 60-121-15] can be removed from the handle sensor wires, use the following procedure. Remove the wedge (Item 1) [Figure…