Disconnect the harness connector (Item 1) [Figure 60-123-31] from the handle sensor connector. Disconnect the harness connector (Item 2) [Figure 60-123-31] from the handle lock…

Remove the actuator from the hydraulic control valve. (See Actuator Removal And Installation on Page 20-41-8.) Check the mounting block (Item 1) [Figure 60-123-29] and…

When installing the new switch handle, tape the wire terminals together. The switch handle comes with a 6 inch piece of heat shrink tube side…

NOTE: Switch handle can be removed and installed while in loader. Disconnect the harness connector (Item 1) [Figure 60-123-11] from the handle sensor connector. Disconnect…

The wire connector (Item 1) [Figure 60-123-8] can be removed from the handle sensor wires, use the following procedure. Remove the wedge (Item 1) [Figure…

Remove control Panel. (See Removal and Installation on Page 50-100-1.) Remove the two mounting bolts (Item 1) [Figure 60-123-6] from the controller mounting bracket. Lift…

The Advanced Control System (ACS) has a built-in diagnostic function which uses an icon on the right instrument panel to indicate the condition of the…

The Advanced Control System (ACS) is a selectable foot/hand control system. The ACS system allows the operator to quickly switch between foot and hand control…

Remove the actuator from the hydraulic control valve. (See Actuator Removal And Installation on Page 20-41-8.) Check the mounting block (Item 1) [Figure 60-122-28] and…