The Loader has a 12 volt, negative ground alternator charging system. The electrical system is protected by a 100 amp master fuse (Item 1) [Figure…

The following troubleshooting chart is provided for assistance in locating and correcting problems which are most common. Many of the recommended procedures must be done…

To replace the rubber boot (Item 1) [Figure 50-114-25] on the control panel, remove the control lever. (See Control Lever Removal and Installation on Page…

Disconnect the electrical connectors (Item 1) [Figure 50-114-21] from the control lever switch handle. Remove the electrical connectors from the control lever switch handle. (See…

Remove the handle sleeve (Item 1) and bushings (Item 2) [Figure 50-114-19] from the handle. Check all parts for wear and replace as needed. Check…

Remove the handle sensor (Item 1) [Figure 50-114-15]. (See Handle Sensor Connector on Page 60-123-5.) Remove the switch handle (Item 1) [Figure 50-114-16]. (See Switch…

Loosen the nuts (Item 1) [Figure 50-114-3]. Installation: Tighten the u-bolts so the lever can not be moved either right or left when seated in…

Control Handle (Item 1) [Figure 50-114-1]. Handle Sensor (Item 1) [Figure 50-114-2]. NOTE: The calibration procedure must be followed when replacing handle sensor, foot pedal…

To replace the rubber boot (Item 1) [Figure 50-113-25] on the control panel, remove the control lever. (See Control Lever Removal and Installation on Page…

Disconnect the electrical connectors (Item 1) [Figure 50-113-21] from the control lever switch handle. Remove the electrical connectors from the control lever switch handle. (See…