Connect the positive (+) voltmeter lead to the positive (+) battery terminal [Figure 60-30-4]. Connect the negative (-) voltmeter lead to the negative (-) battery…

The alternator is removed from the loader for clarity purposes [Figure 60-30-3]. Disconnect the negative (-) cable from the battery. Install the wires in their…

Lift and block the loader. (See LIFTING AND BLOCKING THE LOADER on Page 10-10-1.) Disconnect the negative (-) cable from the battery. NOTE: The photo’s…

Stop the engine. Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.) Loosen the alternator mounting bolt (Item 1) [Figure 60-30-1]. Loosen…

If it is necessary to use a booster battery to start the engine, BE CAREFUL! There must be one person in the operator’s seat and…

The battery cables must be clean and the connections tight. Remove acid or corrosion from the battery and cables with a sodium bicarbonate (baking soda)…

Open the rear door. Disconnect the negative (-) battery cable (Item 1) [Figure 60-20-1]. Remove the battery hold down clamp (Item 2) [Figure 60-20-1]. Disconnect…

Use an Ohm meter to measure coil resistance [Figure 60-10-7]. Coil wires do not have polarity. Correct resistance for the auxiliary, lift and tilt lock…

Remove the cover to check or replace the relays. The location is shown in [Figure 60-10-5 on Page 5] & [Figure 60-10-6].  

Remove the cover to check or replace the fuses.