To remove the handle sensor, slide the rubber handle cover (Item 1) [Figure 50-112-3] up the handle. Disconnect the loader control harness (Item 1) [Figure…

Control Handle (Item 1) [Figure 50-112-1]. Handle Sensor (Item 1) [Figure 50-112-2].  

To replace the rubber boot (Item 1) [Figure 50-111-18] on the control panel, remove the control lever. (See Control Lever Removal And Installation on Page…

Disconnect the electrical connectors (Item 1) [Figure 50-111-14] from the control lever switch handle. Remove the electrical connectors from the control lever switch handle. (See…

Remove the handle sleeve (Item 1) and bushings (Item 2) [Figure 50-111-12] from the handle. Check all parts for wear and replace as needed. Check…

To remove the handle control unit, slide the rubber handle cover (Item 1) [Figure 50-111-3] up the handle. Remove the two mounting bolts (Item 2)…

Control Handle (Item 1) [Figure 50-111-1]. Handle Control Unit (Item 1) [Figure 50-111-2].    

The following tool listed will be needed to do the following procedure: MEL1563 – Remote Start Tool Kit Connect the remote start tool to the…

Push the control lever to full stroke and turn drift adjustment bolt (Item 1) [Figure 50-110-24] in until it touches the U-bolt holding the control…

Remove access plug from the top of the control panel. Turn the control lever drift adjustment bolts (Item 1) [Figure 50-110-17] (one on each control…