Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Lift and block the…

Remove the nut (Item 1) from the end of the centering spring shoulder bolt (Item 2) [Figure 50-110-7]. Remove the shoulder bolt/spring assembly. Installation: Tighten…

To replace the rubber boot (Item 1) [Figure 50-110-6] on the control panel, remove the control lever (See Lever Removal And Installation on Page 50-110-2.)…

Disconnect the electrical connectors from the control lever [Figure 50-110-5]. Remove the nuts from the two U-bolts (Item 1) [Figure 50-110-5] used to mount the…

Disassemble the right and left steering shafts from the cross shaft assembly [Figure 50-110-3]. Assembly: Install new nylon bushings (Item 1) [Figure 50-110-3] as needed…

NOTE: The steering shaft can be removed without removing the control panel from the loader. Photo [Figure 50-               …

Remove the mounting nut (Item 1) [Figure 50-110-1] from the end of the shock connected to the steering linkage. Remove the mounting nut (Item 2)…

Raise the lift arms and install an approved lift arm support device. (See Installing Lift Arm Support Device on Page 10-20-1.) Raise the operator cab.…

Remove the bolt (Item 1) holding the linkage (Item 2) [Figure 50-91-7] to the side of the foot pedal. Remove the spacer (Item 1), linkage…

Remove the pin (Item 1) [Figure 50-91-5] holding the linkage to the sensor. Tip the foot pedal up and remove the two nuts (Item 1)…