Stop the engine. Open rear door. Remove the negative (-) cable from the battery. the battery may be removed for additional working clearance. (See Removal…

Stop the engine. Open the rear door. Raise the operator cab. (See Raising The Operator Cab on Page 10-30-1.) Remove the negative (-) cable from…

To adjust the drive belt between the flywheel and the hydrostatic pump pulley, use the following procedure: Stop the engine. Open the rear door. Disconnect…

Remove the three drive belt shield mounting clips (Item 1) [Figure 30-50-1].  

Install the lower bearing (Item 1) [Figure 30-40-36] on the swashplate. Install the swashplate and bearing into the pump housing [Figure 30-40-37]. Install the tapered…

Remove the four bolts (Item 1) [Figure 30-40-12] from the pump housing end cap. Remove the pump housing end cap (Item 1) [Figure 30-40-13]. Remove…

Remove the four mounting bolts (Item 1) [Figure 30-40-9]. Separate the two hydrostatic pumps [Figure 30-40-10]. Remove the pump coupler (Item 1) [Figure 30-40-11]. Remove…

Remove the pump mounting bolts (Item 1) [Figure 30-40-7] (both sides). Installation: Tighten the mounting bolts to 27-37 ft.-lbs. (37-50 Nm) torque. Remove the hydraulic…